Renault Laguna III Manual page 1232

Exhaust gas recirculation solenoid valve: Removal - Refitting
K9K, and 782
a Fit the tool (Ms. 583) (8) on the cooling pipe of the
exhaust gas recirculation solenoid valve.
a Remove the clip (9) from the cooling pipe of the ex-
haust gas recirculation solenoid valve.
a Disconnect the cooling pipe from the exhaust gas re-
circulation solenoid valve.
a Fit the tool (Ms. 583) (10) on the cooling pipe of the
heater matrix.
a Use the tool (Mot. 1448) to separate the clip on the
cooling pipe of the heater matrix.
a Disconnect the heater matrix cooling pipe on the ex-
haust gas recirculation solenoid valve.
ANTIPOLLUTION
138907
139185
14A-31
a Remove:
- the bolts (12) from the exhaust gas recirculation so-
lenoid valve,
- the exhaust gas recirculation solenoid valve,
- the exhaust gas recirculation solenoid valve seal.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: exhaust gas recir-
culation solenoid valve seal (11,07,01,13).
a Always replace:
- the clip on the cooling pipe of the exhaust gas recir-
culation solenoid valve,
- the turbocharger air inlet pipe seal.
a Use a SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease the sealing
surfaces:
- of the exhaust gas recirculation solenoid valve if it
is being reused,
- of the exhaust gas recirculation support.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- a new seal on the exhaust gas recirculation sole-
noid valve,
14A
139186