Renault Laguna III Manual page 1681

Particle filter temperature sensors: Removal - Refitting
V9X
Special tooling required
Mot. 1807 Spanner for tightening the
exhaust gas temperature sen-
sor
Tightening torquesm
particle filter tempera-
ture sensor
IMPORTANT
Wear protective gloves during the operation.
IMPORTANT
Wear heat protective gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the exhaust heat shield clip (1) .
a Move the exhaust heat shield to one side slightly.
EXHAUST
30 N.m
a Unclip:
- the particle filter temperature sensor connector
- the particle filter temperature sensor wiring from
a Disconnect the particle filter temperature sensor
connector (2) .
a Move aside the particle filter temperature sensor wir-
ing.
124144
19B-115
from the heat shield,
the heat shield.
19B
124145