Renault Laguna III Manual page 1316

F4R
REFITTING
I - REFITTING PREPARATION OPERATION
a Check that the centring dowel (7) is in place.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the starter.
a Fit the starter wiring harness.
a Tighten to torque:
- the nut on the positive terminal of the starter (8
N.m),
- the nut on the excitation terminal of the starter
(7 N.m),
- the earth cable nut on the starter (21 N.m).
a Refit the starter heat shield.
III - FINAL OPERATION.
a Fit the exhaust pipe.
a Refit:
- the exhaust system rubber mounting bush bolt,
- the exhaust bracket nuts,
- the silencer (see 19B, Exhaust, Silencer: Remov-
al - Refitting, page 19B-64) ,
- the catalytic converter rear strut,
STARTING - CHARGING
Starter: Removal - Refitting
21935
a Tighten to torque:
- the catalytic converter rear strut nut (44 N.m),
- the catalytic converter rear strut bolt (8 Nm).
a Refit:
- the front right-hand driveshaft (see Front right-
hand driveshaft: Removal - Refitting) (29A,
Driveshafts),
- the rear suspended engine mounting (see 19D,
Engine mounting, Lower engine tie-bar: Re-
moval - Refitting, page 19D-85) ,
- the engine undertray,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the downstream oxygen sensor (see 17B, Petrol
injection, Oxygen sensors: Removal - Refitting,
page 17B-17) ,
- the cooling hoses clip on the heater matrix.
a Clip on the heater matrix cooling hoses.
a Refit:
- the air filter box (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) ,
- the engine cover.
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
16A-39
16A