Renault Laguna III Manual page 1994

Hydraulic distributor internal wiring: Removal - Refitting
V4Y, and AJ0
Equipment required
Diagnostic tool
Tightening torquesm
tempera t u r e s e n s o r
retaining bolt
internal wiring earth
bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine undertray bolts,
- the engine undertray.
a Drain the automatic gearbox oil (see 23A, Automat-
ic gearbox, Automatic gearbox oil: Draining -
Filling, page 23A-29) .
a Remove the hydraulic distributor (see 23A, Auto-
matic gearbox, Hydraulic distributor: Removal -
Refitting, page 23A-35) .
AUTOMATIC GEARBOX
8 N.m
8 N.m
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Lift the internal wiring retaining clips (1) .
a Disconnect:
- the internal wiring connector (2) ,
- the connectors (3) from the pressure sensors.
a Disconnect the solenoid valve connectors (4) .
a Remove:
- the earth bolts (5) ,
- the bolt (6) from the temperature sensor,
23A-76
23A
134879
134879