Renault Laguna III Manual page 1782

Left-hand suspended engine mounting: Removal - Refitting
F4R, and AJ0
Special tooling required
Mot. 1852 Conversion support studs for
Mot. 1720 tool
Mot. 1720 Engine stand.
Mot. 1672 Lower engine support.
Tightening torquesm
left-hand suspended
engine mounting sup-
port bolts on the gear-
box
upper bolts of the left-
hand suspended engine
mounting rubber pad on
the body
central nut of the sus-
pended engine mount-
ing shaft on the gearbox
tie rod rear bolts
lower engine tie-bar bolt
on the subframe
lower engine tie-bar bolt
on the engine tie-bar
support
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray,
- the front left-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front left-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection).
- the battery (see Battery: Removal - Refitting)
(80A, Battery),
ENGINE MOUNTING
105 N.m
105 N.m
62 N.m
105 N.m
115 N.m
190 N.m
19D-36
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) .
a Remove:
- the bolt (1) from the max fuse box,
- the max fuse box clip (2) .
a Move the max fuse box to one side.
19D
123949