Renault Laguna III Manual page 1642

Particle filter: Removal - Refitting
V9X
Special tooling required
Mot. 1807 Spanner for tightening the
exhaust gas temperature sen-
sor
Equipment required
component jack
Diagnostic tool
Tightening torquesm
particle filter tempera-
ture sensor
particle filter pressure
sensor nut
IMPORTANT
Wear protective gloves during the operation.
IMPORTANT
Wear heat protective gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine undertray bolts,
- the engine undertray,
- the lower engine tie-bars (see 1 9 D, Engine
mounting, Lower engine tie-bar: Removal - Re-
fitting, page 19D-85) .
EXHAUST
II - OPERATION FOR REMOVAL OF PART
CONCERNED
30 N.m
21 N.m
a Remove the exhaust heat shield clip (1) .
a Move the exhaust heat shield to one side slightly.
19B-76
19B
124144