Bgp Wait-On-End-Of-Rib - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

bgp wait-on-end-of-rib

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
bgp wait-on-end-of-rib seconds
no bgp wait-on-end-of-rib
Command introduced in JunosE Release 8.2.0.
Specifies how long BGP waits to receive an End-of-RIB marker sent by route-target
address family peers to signal the peer has finished advertising route-target membership
information. Applies to all peers in the route-target address family. The no version restores
the default value.
seconds—Number of seconds BGP wait for End-of-RIB marker, in the range 1–3600;
default is 60 seconds
Address Family Configuration, Router Configuration
Chapter 3: B Commands
297