Neighbor Rib-Out Disable - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

neighbor rib-out disable

[ no | default ] neighbor { ipAddress | ipv6Address | peerGroupName } rib-out disable
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Disables storage of routes to the Adj-RIBs-Out table (disables rib-out) for the neighbor
Description
or peer group. Storage is disabled by default. The no version enables the route storage.
The default version removes the explicit configuration from the peer or peer group
and reestablishes inheritance of the feature configuration.
NOTE: If you enable or disable rib-out for a peer or peer group and this action changes
the current configuration, the peer session or all peer group sessions are automatically
bounced.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress IP address of BGP neighbor; you can independently enable or disable
the Adj-RIBs-Out table for a peer, regardless of whether it is a member of a peer
group
ipv6Address IPv6 address of BGP neighbor; you can independently enable or
disable the Adj-RIBs-Out table for a peer, regardless of whether it is a member
of a peer group
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, a single Adj-RIBs-Out table is established
for the peer group; BGP does not enable individual Adj-RIBs-Out tables for each
peer group member.
Chapter 2: N Commands
neighbor rib-out disable
59