Layer 2 Control Neighbor Configuration Mode; Ldp Configuration Mode; Line Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Layer 2 Control Neighbor Configuration Mode

LDP Configuration Mode

Line Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
In this mode, you can specify a neighbor ID and the maximum number of branches that
the neighbor can have.
From Global Configuration mode, type neighbor and press Enter.
host1(config-l2c)#neighbor
host1(config-l2c-neighbor)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
id Configure neighbor-id associated with neighbor
log Configure logging settings
macro Run a CLI macro
max-branches Configure max number of branches for neighbor
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can create and configure MPLS Label Distribution Protocol (LDP) profile
parameters.
From Global Configuation mode, type mpls ldp interface profile and the profileName,
and press Enter.
host1(config)#mpls ldp interface profile shell
host1(config-ldp)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
hello Configure hello parameters
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can modify the operation of a virtual terminal (vty) line.
From Global Configuration mode, type the line vty command and either the lineNumber
or the rangeOfLineNumbers you want to configure, and press Enter.
NOTE: The factory default is 5 vty lines. However, you can increase the
number of vty lines available by typing the start number and end number of
the vty line range. Once you execute the line vty command, you will have
access to line numbers up to the ending line number.
Chapter 2: Command-Line Interface
97