Policy Condition Destination Network Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy condition destination network group

Associates a destination network group with a policy condition.
policy condition condition_name destination network group network_group
policy condition condition_name no destination network group
Syntax Definitions
condition_name
network_group
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a destination network group from a condition; however, at
least one classification parameter must be associated with a condition.
•
A destination IP address and a destination IP network group cannot be specified in the same condition.
Examples
-> policy condition cond6 destination network group webgroup1
Release History
Release 6.1; command was introduced.
Related Commands
policy condition
policy network group
qos apply
show policy condition
show policy network group
OmniSwitch CLI Reference Guide
The name of the condition.
The name of the destination network group. Network groups are config-
ured through the policy network group command. See
more information about this command.
Creates a policy condition.
Configures a network group name and its associated IP addresses.
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
Displays information about policy network groups.
June 2012
page 33-17 for
page 33-59