Policy Condition Source Ip Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy condition source ip port

Configures a source IP port number for a policy condition.
policy condition condition_name source ip port port[-port]
policy condition condition_name no source ip port
Syntax Definitions
condition_name
port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a source IP port from a condition; however, at least one
classification parameter must be associated with a condition.
•
The protocol (TCP or UDP) must be specified in the condition, either on the same command line or in
a previous command. Use the ip protocol keywords. See the
information.
•
The same condition cannot specify a source IP port with a source TCP port, source UDP port, service,
or service group.
Examples
-> policy condition cond1 ip protocol 6 source ip port 137
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy condition ip protocol
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The TCP or UDP port number of the source address of the Layer 3 flow,
in the range from 0–65535. A range of ports (separated by a hyphen)
may be specified instead of a single port.
Applies configured QoS and policy settings to the current configuration.
Configures an IP protocol for a policy condition.
Shows information about policy conditions configured on the switch.
June 2012
policy condition ip protocol for more
page 33-63