Policy Condition Destination Ip Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy condition destination ip port

Configures a destination IP port number for a policy condition.
policy condition condition_name destination ip port port[-port]
policy condition condition_name no destination ip port
Syntax Definitions
condition_name
port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a destination IP port from a condition; however, at least
one classification parameter must be associated with a condition.
•
The protocol (TCP or UDP) must be specified in the same condition, either on the same command line
or in a previous command. Use the ip protocol keywords. See the
command for more information.
•
The same condition cannot specify a destination IP port with a service or service group.
Examples
-> policy condition cond2 ip protocol 6 destination ip port 137-138
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy condition ip protocol
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The TCP or UDP port number (or port range) of the destination address
of the Layer 3 flow, in the range from 0–65535. A range of ports (sepa-
rated by a hyphen) may be specified instead of a single port.
Applies configured QoS and policy settings to the current configuration.
Configures an IP protocol for a policy condition.
Shows information about policy conditions configured on the switch.
June 2012
policy condition ip protocol
page 33-65