Nqa Server Udp-Echo - H3C MSR 20-20 Command Reference Manual

Related command:
Example

nqa server udp-echo

Syntax
View
Parameter
Description
Related command:
Example
Note that:
You need to configure the command on the NQA server for TCP tests only.
■
The IP address and port number must be consistent with those on the NQA
■
client and must be different from those for an existing listening service.
The IP address must be that of an interface on the NQA server. Otherwise, the
■
configuration will be invalid.
nqa server enable.
# Create a TCP listening service by using the IP address 169.254.10.2 and port
9000.
<Sysname> system-view
[Sysname] nqa server tcp-connect 169.254.10.2 9000
nqa server udp-echo ip-address port-number
undo nqa server udp-echo ip-address port-number
System view
ip-address: IP address specified for the UDP listening service on the NQA server.
port-number: Port number specified for the UDP listening service on the NQA
server, in the range 1 to 50000.
Use the
nqa-server udpecho
NQA server.
Use the
undo nqa-server udpecho
service created.
Note that:
You need to configure the command on the NQA server for UDP-jitter and
■
UDP-echo tests only.
The IP address and port number must be consistent with those configured on
■
the NQA client and must be different from those of an existing listening
service.
The IP address must be that of an interface on the NQA server. Otherwise, the
■
configuration will be invalid.
nqa server enable.
# Create a UDP listening service by using the IP address 169.254.10.2 and port
9000.
command to create a UDP listening service on the
command to remove the UDP listening
2291