Probe Count - H3C MSR 20-20 Command Reference Manual

2278 C 149: NQA C
HAPTER
Parameter
Description
Related command:
Example

probe count

Syntax
View
Parameter
Description
C C
LIENT ONFIGURATION OMMANDS
password: Password used to log onto the FTP server, a string of 1 to 32 characters.
It is case sensitive.
Use the password
server.
Use the
undo password
By default, no password is configured for logging onto the FTP server.
"username (FTP test type view)" on page 2287, "operation (FTP test type view)"
on page 2276.
# Configure the password used for logging onto the FTP server as ftpuser.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type ftp
[Sysname-nqa-admin-test-ftp] password ftpuser
probe count times
undo probe count
Any NQA test type view
times: Number of probes in a test, in the range 1 to 15.
Use the
probe count
Use the
undo probe count
By default, one probe is performed in a test.
For a TCP or DLSw test, one probe means one connection;
■
For a UDP-jitter test, the number of packets sent in one probe depends on the
■
probe packet-number command;
For an FTP, HTTP or DHCP test, one probe means to carry out a corresponding
■
function;
For an ICMP-echo or UDP-echo test, one packet is sent in one probe;
■
For an SNMP test, three packets are sent in a probe.
■
If the number of probes in a test is greater than 1, the system sends a second
packet after it sends the first packet and receives a response packet. If the system
does not receive a response packet, it waits for the test timer to expire before
sending a second probe packet. The process is repeated until the specified probes
are completed.
command to configure a password used to log onto the FTP
command to remove the configured password.
command to configure the number of probes in a test.
command to restore the default.