Probe Packet-Interval; Probe Packet-Number - H3C MSR 20-20 Command Reference Manual

Example

probe packet-interval

Syntax
View
Parameter
Description
Example

probe packet-number

Syntax
View
Parameter
Description
# Configure the number of probes in an ICMP-echo test as 10.
<Sysname> system-view
[Sysname] nqa entry admin-test
[Sysname-nqa-admin-test] type icmp-echo
[Syaname-nqa-admin-test-icmp-echo] probe count 10
probe packet-interval packet-interval
undo probe packet-interval
UDP-jitter test type view
packet-interval: Interval for consecutive packets sent, in milliseconds, in the range
10 to 1000.
Use the probe packet-interval
consecutive packets.
Use the
undo probe-interval
By default, the interval for sending consecutive packets is 20 milliseconds.
# Configure the interval for sending consecutive packets as 100 milliseconds.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Syaname-nqa-admin-test-udp-jitter] probe packet-interval 100
probe packet-number packet-number
undo probe packet-number
UDP-jitter test type view
packet-number: Number of consecutive packets sent in a UDP-jitter test, in the
range 10 to 1000.
Use the
probe packet-number
consecutive packets sent in a UDP-jitter probe.
Use the undo probe packet-number
By default, the number of consecutive packets in a probe is 10.
command to configure the interval for sending
command to restore the default.
command to configure the number of
command to restore the default.
2279