Destination Ip; Destination Port - H3C MSR 20-20 Command Reference Manual

destination ip

Syntax
View
Parameter
Description
Example

destination port

Syntax
View
Parameter
Description
Example
destination ip ip-address
undo destination ip
DLSw/FTP/HTTP/ICMP-echo/SNMP/TCP/UDP-echo/UDP-jitter test type view
ip-address: Destination IP address of a test operation.
Use the
destination ip
operation.
Use the undo destination ip
address.
By default, no destination IP address is configured for a test operation.
# Configure the destination IP address of an ICMP-echo test operation as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] destination ip 10.1.1.1
destination port port-number
undo destination port
TCP/UDP-echo/UDP-jitter test type view
port-number: Destination port number of a test operation, in the range 1 to
65535.
Use the
destination port
a test operation.
Use the
undo destination port
port number.
By default, no destination port number is configured for a test operation.
Note that you are not recommended to perform a TCP, UDP-echo, or UDP-jitter
test on ports from 1 to 1023 (known ports). Otherwise, the NQA test will fail or
the corresponding services of this port will be unavailable.
# Configure the destination port number of a test operation as 9000.
command to configure a destination IP address for a test
command to remove the configured destination IP
command to configure a destination port number for
command to remove the configured destination
2267