Display Vrrp Ipv6 - H3C MSR 20-20 Command Reference Manual

display vrrp ipv6

Syntax
View
Parameter
Description
Example
147
VRRP C
ONFIGURATION
IP 6
FOR V
display vrrp ipv6 [ verbose ] [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Any view
verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the
specified interface. interface-type interface-number specifies an interface by its
type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to
255.
Use the display vrrp ipv6
IPv6.
If you do not specify verbose, only the brief state information of VRRP is
displayed.
If you specify both interface and standby group, only the state information of the
specified standby group is displayed; if you only specify an interface, the state
information of all the standby groups on the interface is displayed; if you specify
neither, the state information of all the standby groups on the device is displayed.
# Display brief information about all VRRP standby groups on the device for IPv6.
<Sysname> display vrrp ipv6
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
The total number of the virtual routers: 1
Interface VRID
---------------------------------------------------------------------
Eth1/0 1
# Display detailed information about all standby groups on the device.
command to display the state information of VRRP for
State Run
Pri
Master 100 100
C
OMMANDS
Adver. Auth Virtual
Time Type IP
NONE FE80::1
2237