Source Interface - H3C MSR 20-20 Command Reference Manual

Description
Example

source interface

Syntax
View
Parameter
Description
Related command:
Example
Use the
route-option bypass-route
bypass function to test the direct connectivity to the direct destination.
Use the
undo route-option bypass-route
table bypass function.
By default, the routing table bypass function is disabled.
Note that after this function is enabled, the routing table is not searched, and the
packet is directly sent to the destination in a directly connected network.
# Enable the routing table bypass function.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface interface-type interface-number
undo source interface
ICMP-echo test type view
interface-type interface-number: Interface type and the interface number of the
source interface of a probe packet.
Use the
source interface
the source IP address of ICMP-echo probe requests.
Use the undo source interface
interface as the source IP address of ICMP-echo probe requests.
By default, no interface address is specified as the source IP address of ICMP test
request packets.
Note that:
If you use the source ip command to configure the source IP address of ICMP
■
probe requests, the source interface command is invalid.
The interface specified by the source interface command can only be a Layer
■
3 Ethernet interface or VLAN interface.
The interface specified by the source interface command must be up;
■
otherwise, the probe fails.
source ip.
# Specify the IP address of interface Ethernet 1/0 as the source IP address of
ICMP-echo probe requests.
command to enable the routing table
command to disable the routing
command to specify the IP address of an interface as
command to remove the IP address of an
2283