Redundancy Configuration Mode; Remote Neighbor Configuration Mode - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Redundancy Configuration Mode

In this mode, you can activate high availability (SRP switchover) by issuing the mode
high-availability command.
From Global Configuration mode, type the redundancy command and press Enter.
host1(config-router)#redundancy
host1(config-redundancy)#?

Remote Neighbor Configuration Mode

In this mode, you can configure remote neighbor parameters for Routing Information
Protocol (RIP), Protocol Independent Multicast (PIM), and Open Shortest Path First
(OSPF).
From Global Configuration mode, type either router rip, router pim, or router ospf
and the processID. Press Enter. You are now in Router Configuration mode.
From Router Configuration mode, type the remote-neighbor command and the
appropriate attributes, and press Enter.
host1(config-router)#remote-neighbor 10.13.5.61
host1(config-router-rn)#?
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
mode Configure redundancy mode
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
authentication Configure authentication
default Set a command to its default(s)
distribute-list Specify an access list to be a distribute list
do Run an exec mode command (alias command run)
exit Exit from the current command mode
exit-remote-neighbor Exit the remote-neighbor configuration mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
receive Set reception characteristics
route-map Specify a route map to apply to outgoing routes
run Run an exec mode command (alias command do)
send Set transmit characteristics
sleep Make the Command Interface pause for a specified
duration
split-horizon Enable Split-horizon
time-to-live Configure ttl used to send to this neighbor
update-source Source address to be used for transmit
Chapter 2: Command-Line Interface
Accessing Command Modes
115