Redundancy Configuration Mode; Remote Neighbor Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Redundancy Configuration Mode

Remote Neighbor Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
no Negate a command or set its default(s)
peak-burst Set the peak burst size in Bytes
peak-rate Set the peak access rate in bits per second
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can activate high availability (SRP switchover) by issuing the mode
high-availability command.
From Global Configuration mode, type the redundancy command and press Enter.
host1(config-router)#redundancy
host1(config-redundancy)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
mode Configure redundancy mode
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can configure remote neighbor parameters for Routing Information
Protocol (RIP), Protocol Independent Multicast (PIM), and Open Shortest Path First
(OSPF).
From Global Configuration mode, type either router rip, router pim, or router ospf and
the processID. Press Enter. You are now in Router Configuration mode.
From Router Configuration mode, type the remote-neighbor command and the
appropriate attributes, and press Enter.
host1(config-router)#remote-neighbor 10.13.5.61
host1(config-router-rn)#?
authentication
default
distribute-list
do
exit
exit-remote-neighbor
help
log
macro
no
receive
route-map
run
send
sleep
split-horizon
time-to-live
update-source
Configure authentication
Set a command to its default(s)
Specify an access list to be a distribute list
Run an exec mode command (alias command run)
Exit from the current command mode
Exit the remote-neighbor configuration mode
Describe the interactive help system
Configure logging settings
Run a CLI macro
Negate a command or set its default(s)
Set reception characteristics
Specify a route map to apply to outgoing routes
Run an exec mode command (alias command do)
Set transmit characteristics
Make the Command Interface pause for a specified
duration
Enable Split-horizon
Configure ttl used to send to this neighbor
Source address to be used for transmit
Chapter 2: Command-Line Interface
107