Assigning A Proxy Server An Auto-Update Server (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Configuring Secure Access Devices Guide

Assigning a Proxy Server an Auto-Update Server (NSM Procedure)

Table 69: Proxy Server as Auto-Update Server details
Options
Download path
Download interval
Username and Password
Use Proxy Server
IP Address
Port
Related
Documentation
250
To use a proxy server as an auto-update server:
In the navigation tree, select Device Manager > Devices. Click the Device Tree tab,
1.
and then double-click the Secure Access device for which you want to use the proxy
server as an auto-update server.
Click the Configuration tab and select Authentication > Endpoint Security > Host
2.
Checker.
Click either Virus signature version monitoring or Patch Management Info Monitoring.
3.
Select either Auto-update virus signatures list or Auto-update Patch Management
4.
data.
Configure settings as described in Table 69 on page 250.
5.
If your proxy server is password protected, type the username and password of the
6.
proxy server.
Click one:
7.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
Specifies the existing URLs of the staging sites where the current lists are stored. The
default URLs are the paths to the Juniper Networks staging site:
https://download.juniper.net/software/av/uac/epupdate_hist.xml
https://download.juniper.net/software/hc/patchdata/patchupdate.dat
Specifies how often you want the device to automatically import the current list(s).
Enter your Juniper Networks Support credentials.
Select the check box to enable this feature.
Enter the IP address of your proxy server.
Enter the port that the Juniper Networks Support site will use to communicate with
your proxy server.
Configuring Virus Signature Version Monitoring (NSM Procedure) on page 248
Importing Virus Signature Version Monitoring or Patch Management Version Monitoring
List (NSM Procedure) on page 249
Copyright © 2010, Juniper Networks, Inc.