ntp client
Enables or disables NTP time synchronization discipline.
ntp client {enable | disable}
Syntax Definitions
enable
disable
Defaults
NTP protocol is disabled by default.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to enable or disable NTP. Before NTP can be enabled, an NTP server must be speci-
fied using the
ntp server
•
It is not necessary to specify an NTP server if the NTP client will only receive time updates from NTP
broadcast servers.
Examples
-> ntp client enable
-> ntp client disable
Release History
Release 6.1; command was introduced.
Related Commands
ntp server
MIB Objects
alaNtpEnable
page 56-6
Enables NTP.
Disables NTP.
command. Up to 3 NTP servers may be defined.
Specifies an NTP server from which the switch will receive updates.
Network Time Protocol Commands
OmniSwitch CLI Reference Guide
June 2012