Chapter 3: Installing An Ig550 Integrated Gateway With The J-Web Quick Configuration Interface; Checking Juniper Firmware Compatibility - Avaya IG550 Installing And Configuring

Chapter 3: Installing an IG550 Integrated Gateway
Note:
To add the TGM550 to a J-series router that is already operating, see
Note:
5: Installing an IG550 Integrated Gateway with an existing Juniper J4350/J6350
Services Router
In this scenario, the customer adds a new site to the LAN, WAN, or both. You must install
both a router and a TGM550. This procedure assumes that you do not have a Disk-on-Key
USB memory stick.

Checking Juniper firmware compatibility

The software for the J-series router must be release 8.4 or higher. If it is not, upgrade the router
software to release 8.4 before continuing with the installation. See the Juniper J2320, J2350,
J4350, and J6350 Services Router Getting Started Guide, Release 8.4.
!
CAUTION:
Neither the Telephony Interface Modules (TIMs) nor the TGM550 should be
CAUTION:
inserted into the J-series router before you are sure the router is running release
8.4 or higher. Failure to comply with this caution may cause your system to
become inoperable.
Also, check what Juniper software is compatible with the specific TGM550 firmware load you
are downloading. You might need to install newer router firmware before you install new
TGM550 firmware.
1. Go to http://support.avaya.com, and select Communication Manager from the most
popular documents list or by searching by product name.
2. Search All Documents for Communication Manager Software & Firmware Compatibility
Matrix.
with the J-Web
Quick Configuration interface
on page 117.
Chapter
Issue 2 January 2008 45