Foreign Exchange Station/Direct Inward Dial (Fxs/Did) Interface Modules - Avaya Advanced Gateway 2330 Installation Manual

Warning:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables are connected to
a light source.
Caution:
If you do not install interface modules in slots, keep the metal cover plates in place over the
slots. Removing the cover plates impedes airflow and proper cooling of the unit.
Foreign Exchange Station/Direct Inward Dial (FXS/DID) Interface
Modules
Important:
Ensure you use standard straight-through RJ11 modular telephone cables with FXS/DID
interface modules. TIP must connect to TIP and RING must connect to RING. FXS/DID
ground start does not work if polarity is reversed.
Important:
Avaya does not support FXS/DID port connections leaving the building. Use FXS/DID
connections for intra-building purposes only.
Warning:
The 2- and 4-port FXS/DID interface modules have a ring signal generator that is a source of
hazardous voltage. Do not touch the RJ11 port conductors, the conductors of a cable (that
is, the exposed metal ends of a cable connector) connected to the RJ11 port, or the circuit
board when the ringer is active (an incoming call activates the ringer).
Installation — Hardware Components
Safety requirement for handling and installing modules
August 2010 7