Next Steps; Using Avaya Iw And Giw; Using The Command Line Interface - Avaya G250 Quick Start For Hardware Installation

Hide thumbs Also See for G250:

Table of Contents

Note:

You must provide the loop start dial tone for the modem to dial in to the Media

Note:

Gateway.

1. From the Wizard Usage Options screen, select Enable the modem for remote

installation, and click Continue.The Modem Type Selection screen appears

2. Select the type of modem you are using, and click Continue.

3. Verify that the modem parameters are correct for the type of modem that you selected. Click

Continue. The Connect Modem screen appears.

4. From the Connect Modem screen, click Finish to exit the Gateway Installation Wizard.

5. Connect the modem that you specified in Step 2 and plug in a loop start dial tone line into it .

6. Dial in to the modem to ensure that it is set up correctly.

7. A remote technician can now dial in to the G250 and complete the configuration using the

CLI interface.

Next steps

The full configuration process is performed using the Avaya Installation Wizard or Gateway

Installation Wizard interface. For more detailed information about IW and GIW:

See the online help for IW and GIW at http://support.avaya.com/avayaiw.

●

Review Job Aid: Avaya Installation Wizard, 555-245-754, and Job Aid: Avaya Gateway

●

Installation Wizard, 555-245-756.

For information about configuring the G250 with the Command Line Interface:

For instructions on how to connect to the CLI, review Chapter of Administration for the

●

Avaya G250 and Avaya G350 Media Gateways, 03-300436 - Accessing the Avaya G250/

G350 Media Gateway.

For detailed information about CLI commands, refer to the Avaya Aura G250 and Avaya

●

Aura G350 CLI Reference, 03-300437.

Next steps

Issue 5 November 2009

Table of Contents