Show Ip Route - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

R C
OUTING OMMANDS

SHOW IP ROUTE

show ip route
Overview Use this command to display routing entries in the FIB (Forwarding Information
Base). The FIB contains the best routes to a destination, and your device uses these
routes when forwarding traffic. You can display a subset of the entries in the FIB
based on protocol.
To modify the lines displayed, use the | (output modifier token); to save the output
to a file, use the > output redirection token.
show ip route [connected|rip|static|<ip-addr>|
Syntax
<ip-addr/prefix-length>]
Mode User Exec and Privileged Exec
Example To display the static routes in the FIB, use the command:
awplus#
Output Each entry in the output from this command has a code preceding it, indicating the
source of the routing entry. The first few lines of the output list the possible codes
that may be seen with the route entries.
Typically, route entries are composed of the following elements:
•
•
•
•
•
•
•
613-50157-01 Rev C
Parameter
connected
rip
static
<ip-addr>
<ip-addr/prefix-length> Displays the routes for the specified network. Enter
show ip route static
code
a second label indicating the sub-type of the route
network or host IP address
administrative distance and metric
next hop IP address
outgoing interface name
time since route entry was added
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
Displays only the routes learned from connected
interfaces.
Displays only the routes learned from RIP.
Displays only the static routes you have configured.
Displays the routes for the specified address. Enter
an IPv4 address.
an IPv4 address and prefix length.
639