Figure 3: Configuring An Atm Interface, Subinterface, And Pvc - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Figure 3: Configuring an ATM Interface, Subinterface, and PVC

ERX14xx models (rear view)
atm pvc
Copyright © 2010, Juniper Networks, Inc.
Configure an ATM physical interface.
1.
host1(config)#interface atm 0/1
Configure an ATM 1483 subinterface.
2.
host1(config-if)#interface atm 0/1.20
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation type.
3.
host1(config-subif)#atm pvc 10 15 22 aal5snap
Assign an IP address and subnet mask to the PVC.
4.
host1(config-subif)#ip address 192.32.10.20 255.255.255.0
(Optional) Verify your configuration using the appropriate show commands.
5.
host1#show atm interface atm 0/1
host1#show atm vc atm 0/1 10
host1#show atm subinterface atm 0/1.20
Use to configure a PVC on an ATM interface.
Specify one of the following encapsulation types:
aal5snap—Specifies an LLC encapsulated circuit; LLC/SNAP header precedes the
protocol datagram.
aal5mux ip—Specifies a VC-based multiplexed circuit. This option is used for IP only.
Chapter 1: Configuring ATM
21