Oam-Pvc - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

oam-pvc

oam-pvc [ manage ] [ loopbackFrequency ]
Syntax
no oam-pvc [ manage ]
Command introduced in JUNOSe Release 7.1.0.
Release Information
ATM VC Class Configuration mode added in JUNOSe Release 7.3.0.
In ATM VC Configuration mode, enables generation of F5 OAM loopback cells on an
Description
ATM PVC and, optionally, enables F5 OAM VC integrity features that affect the
operational state of the circuit. The oam-pvc command is valid only for data PVCs
configured with aal5snap, aal5autoconfig, or aal5mux ip encapsulation; you cannot
use this command for data PVCs with other encapsulation types or for control (ILMI
or signaling) PVCs. The no version restores the default behavior, which disables F5
OAM VC integrity and restores the default value for loopback frequency.
In ATM VC Class Configuration mode, enables generation of F5 OAM loopback cells
and, optionally, enables F5 OAM VC integrity features as part of a VC class definition
that you assign to an ATM data PVC. The no version restores the default behavior,
which disables F5 OAM VC integrity and restores the default loopback frequency, in
the VC class.
Options
ATM VC Configuration, ATM VC Class Configuration
Mode
110
oam-pvc
manage Enables F5 OAM VC integrity on the ATM PVC
loopbackFrequency Number of seconds, in the range 1–600, for the router to
wait between the transmission of loopback cells during normal operation; default
value is 10