clock source
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
clock source { line | internal { module | chassis } }
no clock source
Command introduced before JunosE Release 7.1.0.
Determines how an interfaces obtains clocking signals. The no version restores the default
value, line.
line—Interface clocks data from a clock recovered from the line's receive data stream;
the default.
internal—Internal clock source transmits data from its internal clock. You must specify
one of the following for internal clocking:
module—Internal clock is from the line module itself
chassis—Internal clock is from the configured system clock
Controller Configuration, Interface Configuration (POS only)
Chapter 4: C Commands
433