Network Time Protocol Commands
ntp broadcast-client
Enables or disables the NTP client to receive time updates from NTP broadcast servers.
ntp broadcast {enable | disable}
Syntax Definitions
enable
disable
Defaults
Broadcast mode is disabled by default.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Broadcast mode is intended for operation on networks with numerous workstations and where the
highest accuracy is not required. In a typical scenario, one or more time servers on the network broad-
cast NTP messages that are received by NTP hosts. Correct time is determined from this NTP message
based on a pre-configured latency or broadcast delay in the order of a few milliseconds.
•
In order to configure NTP in broadcast client mode, it is required to define the network server to client
broadcast delay.
Examples
-> ntp broadcast-client enable
-> ntp broadcast-client disable
Release History
Release 6.1; command was introduced.
Related Commands
ntp broadcast-delay
MIB Objects
alaNtpBroadcastEnable
OmniSwitch CLI Reference Guide
Enables the client broadcast mode.
Disables the client broadcast mode.
Sets the broadcast delay time in microseconds.
June 2012
page 56-9