QoS Policy Commands
policy condition destination ipv6
Configures a destination IPv6 address for a policy condition.
policy condition condition_name destination ipv6 {any | ipv6_address [mask netmask]}
policy condition condition_name no destination ipv6
Syntax Definitions
condition_name
any
ipv6_address
netmask
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a destination IPv6 address from a condition; however, at
least one classification parameter must be associated with a condition.
•
If a mask is not specified, the IPv6 address is assumed to be a host address.
Examples
-> policy condition cond3 destination ipv6
Release History
Release 6.1.3; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
Any destination IPv6 address.
A specific destination IPv6 address.
The mask for the source IPv6 address.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about a particular policy condition configured on the
switch.
June 2012
::1234:531F:BCD2:F34A
page 33-53