Policy Condition Multicast Ip - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy condition multicast ip

Configures a multicast IP address for a policy condition.
policy condition condition_name multicast ip ip_address [mask netmask]
policy condition condition_name no multicast ip
Syntax Definitions
condition_name
ip_address
netmask
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
If a mask is not specified, the IP address is assumed to be a host address.
•
A multicast IP address and a multicast network group cannot be specified in the same condition.
•
Use the no form of the command to remove a multicast IP address from a condition; however, at least
one classification parameter must be associated with a condition.
•
An IP multicast condition is used in IGMP ACLs. The multicast IP is the multicast group address used
in the IGMP report packet.
Examples
-> policy condition cond4 multicast ip 224.1.1.1
Release History
Release 6.1; command was introduced.
Related Commands
policy condition
qos apply
OmniSwitch CLI Reference Guide
The name of the condition.
The multicast IP address.
Optional. The mask for the multicast IP address.
Creates a policy condition.
Applies configured QoS and policy settings to the current configuration.
June 2012 page 33-55