QoS Policy Commands
[inner source vlan group mac_group]
[destination vlan vlan_id]
[802.1p 802.1p_value]
[source port slot/port[-port]]
[source port group group_name}
[destination port slot/port[-port]]
[destination port group group_name]
[vrf { vrf_name | default}]
no policy condition condition_name
Syntax Definitions
condition_name
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
A policy condition and a policy action are combined to make a policy rule. See the
command for more information.
•
Use the
qos apply
•
If multiple keywords are defined for a single condition, the traffic flow must match all of the parame-
ters in the condition before the rule is enforced.
•
Use the no form of the command to remove a condition from a policy rule.
•
At least one parameter must be associated with a condition.
•
If the snapshot command is entered after the policy condition command is configured, the resulting
ASCII file will include the following additional syntax for the policy condition command:
from {cli | ldap | blt}
This syntax indicates how the condition was created. The cli and ldap options may be changed by a
user modifying the ASCII file; however, changing this setting is not recommended. The blt option
indicates a built-in condition, this option is not configurable.
Examples
-> policy condition cond4 source port 3/1
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the condition. Any alphanumeric string.
command to activate configuration changes.
June 2012
policy rule
page 33-43