Policy Condition Source Ip - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy condition source ip

Configures a source IP address for a policy condition.
policy condition condition_name source ip ip_address [mask netmask]
policy condition condition_name no source ip
Syntax Definitions
condition_name
ip_address
netmask
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
If a mask is not specified, the IP address is assumed to be a host address.
•
A source IP address and a source IP network group cannot be specified in the same condition.
•
Use the no form of the command to remove a source IP address from a condition; however, at least one
classification parameter must be associated with a condition.
Examples
-> policy condition cond3 source ip 173.201.18.3
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The source IP address of the Layer 3 flow.
The mask for the source IP address.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about a particular policy condition configured on the
switch.
June 2012 page 33-47