Setting Terminal Parameters; Starting The Router For The First Time; Flowchart - H3C CR16000-M Installation Manual

Setting terminal parameters

To configure and manage the router through the console port, you must run a terminal emulator
program, TeraTermPro or PuTTY, on your configuration terminal. You can use the emulator program
to connect a network device, a Telnet site, or an SSH site. For more information about the terminal
emulator programs, see the user guides for these programs.
Configure the terminal parameters as follows:
•
Bits per second—9600.
•
Data bits—8.
•
Stop bits—1.
•
Parity—None.
•
Flow control—None.

Starting the router for the first time

Flowchart

To start the router for the first time, use the flowchart in Figure7-2.
7-2