Verifying The Installation; Accessing The Router For The First Time - H3C MSR810 Series Manual

Figure2-23 Connecting the power cord for the RT-MSR810-10-PoE

Verifying the installation

After you complete the installation, verify the following information:
•
There is enough space around the router for heat dissipation.
•
The router is securely installed.
•
Antennas and USB devices are installed correctly.
•
The router and power source are reliably grounded.
•
The power source is as required by the router.
•
The router is connected correctly to the configuration terminal and other devices. Parameters
are configured correctly on the configuration terminal.

Accessing the router for the first time

WARNING!
Before powering on the router, locate the switch for the power source so that you can cut off power
promptly in case of an emergency.
For a router starting with empty configuration, you must press Ctrl+D to access the CLI.
To access the router for the first time:
1. Verify that the installation and configuration environment is as described in
installation."
2. Power on the router.
3. During the booting process, verify the following items:
The LEDs on the front panel indicate normal operation. For more information about the

LEDs, see H3C MSR810 Routers Hardware Information and Specifications.
The configuration terminal displays information correctly.

The router first initializes its memory at startup and then runs BootWare.
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Booting Normal Extend BootWare
Do you want to check SDRAM? [Y/N]
****************************************************************************
2-21
"Verifying the