Accessing The Router For The First Time - H3C MSR5620 Manual

Figure 53 Completing the device driver installation wizard
Setting terminal parameters
To access the device through the console port, you must run a terminal emulator program
(HyperTerminal, PuTTY, or Tera Term) on the configuration terminal. For information about using a
terminal emulator program, see the program's user guide.
The following are the required terminal settings:
•
Baud rate—9600.
•
Data bits—8.
•
Stop bits—1.
•
Parity—none.
•
Flow control—none.

Accessing the router for the first time

WARNING!
Before powering on the router, locate the switch for the power source so that you can cut off power
promptly in case of an emergency.
To access the router for the first time:
1. Verify the installation and configuration environment is as described in
installation."
2. Power on the router.
3. During the booting process, verify the following items:
The LEDs on the front panel of the active MPU indicate normal operation.

The configuration terminal displays information correctly.

36
"Verifying the