Ip Rip Split-Horizon - Avaya G450 Cli Reference Manual

Parameters
Parameter
mode
default_
route_metric
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To set the RIP protocol to receive and transmit updates on the Serial interface:
G450-001(if:Serial 3/1:1)# ip rip send-receive-mode talk-listen
Related Commands
ip distribution access-list,
default-route-mode,
ip protocols

ip rip split-horizon

Use the ip rip split-horizon command to enable the split-horizon mechanism on the
current interface. Use the no form of this command to disable the split-horizon mechanism. By
default split-horizon is enabled.
The split-horizon mechanism prevents information about routes from exiting the router interface
through which the information was received. This prevents routing loops.
Description
The RIP send and
receive mode
The route metric
index
ip rip authentication
ip rip poison-reverse,
Possible Values
talk-listen — RIP receives
and transmits updates on the
interface
talkdefault-listen — RIP
receives updates on the
interface and sends only a
default route
listen-only — RIP receives
updates on the interface and
does not transmit them
1-15
key, ip rip authentication
ip rip rip-version, ip rip
Default Value
talk-listen
mode, ip rip
split-horizon, router rip,
Issue 1 January 2008
RIP
show
863