Ip Softphone Shared Administrative Identity In Sls Mode - Avaya G250 Administration

Contact Closure / SLS feature interactions
There is no screening to authorize Contact Closure feature use in SLS mode. Security is
●
provided by limiting the number of users who know the correct key sequence required for
the Contact Closure feature.
You cannot use the Hold or Transfer features while dialing the Contact Closure FAC key
●
sequence.
Contact Closure will not work until you dial the full digit sequence and it is processed.
●
If two users try to simultaneously use Contact Closure, whoever dials the full FAC key
●
sequence first gets precedence.
Interdigit timing rules apply to the Contact Closure feature, so that if you pause too long
●
during the FAC key sequence, the feature times out.
Call appearances are not released (available for calls) until you hang up.
●
You cannot use the Contact Closure feature from outside trunk lines.
●
Note:
For more information on Contact Closure, refer to
Note:
page 301.

IP Softphone shared administrative identity in SLS mode

The SLS mode supports shared administrative identity with the Avaya Softphone application,
but requires specific station administration.
1. Access the CM administrative SAT interface. For instructions on accessing the Avaya
Communication Manager through the G250/G350, see
page 76.
2. At the SAT, interface, type change station extension and press Enter to display the
Station form.
3. Set the Terminal Type field to a 46xx IP phone.
4. Save the changes.
Note:
If you administer the Terminal Type field as a DCP phone, shared administrative
Note:
identity functionality in SLS mode is not supported.
Configuring contact closure
Accessing the registered MGC
Issue 3 February 2007
on
on
111