Ip Softphone Shared Administrative Identity In Sls Mode; Emergency Transfer In Sls Mode - Avaya G250 Administration Manual

You cannot use the contact closure feature from outside trunk lines.
●
Note:
For more information on contact closure, refer to
Note:
page 371.

IP Softphone shared administrative identity in SLS mode

The SLS mode supports shared administrative identity with the Avaya Softphone application,
but requires specific station administration.
1. Access the CM administrative SAT interface. For instructions on accessing the Avaya
Communication Manager through the G250/G350, see
page 97.
2. At the SAT interface, enter change station extension to display the Station form.
3. Set the Terminal Type field to a 46xx IP phone.
4. Save the changes.
Note:
If you administer the Terminal Type field as a DCP phone, shared administrative
Note:
identity functionality in SLS mode is not supported.

Emergency Transfer in SLS mode

Emergency Transfer Relay (ETR) on the gateway connects or "latches" an analog loop-start CO
trunk port to an analog station port, allowing the user to access the PSTN for emergency calls in
these conditions:
Power outage
●
Loss of controller, including SLS, dropping calls on either the trunk port or the station port.
●
Once the gateway registers with SLS, ETR unlatches.
set etr CLI command can set ETR to:
●
- auto, meaning that the ETR ports are connected if no controller is active.
- on, meaning that the connection is always present.
- off, meaning that the connection is never made. However, if there was a connection
and ETR is set to off, the call stays up until it is disconnected, normally making the
ETR ports available.
Configuring contact closure
Accessing the registered MGC
Issue 5 June 2008
on
on
143