Ip Igmp Last-Member-Query-Interval - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ip igmp last-member-query-interval
Syntax
Release Information
Description
Options
Mode
818
ip igmp last-member-query-interval tenthsOfaSecond
no ip igmp last-member-query-interval
Command introduced before JunosE Release 7.1.0.
Specifies in tenths of a second the maximum time the router waits for a response after
sending a last member query. The router sends a last member query when it receives an
IGMPv2 leave message or an IGMPv3 state change report. The no version restores the
default value, 10 tenths of a second (1 second).
tenthsOfaSecond—Time interval between receipt of an IGMP leave message and
sending out of a query in the range 1–254 tenths of a second. Using a lower value allows
members to leave groups more quickly.
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers