Table of Contents
Advertisement
14.3.6
Serial Control Register (SCR)
SCR is a register that performs enabling or disabling of SCI transfer operations and interrupt
requests, and selection of the transfer clock source. For details on interrupt requests, see section
14.8, Interrupt Sources. Some bits in SCR have different functions in normal mode and smart card
interface mode. The CPU can always read SCR. The CPU can write to SCR only at the initial
settings; do not have the CPU write to SCR in transmission, reception, and simultaneous data
transmission and reception.
• Bit Functions in Normal Serial Communication Interface Mode (when SMIF in SCMR = 0)
Bit
Bit Name
7
TIE
6
RIE
5
TE
4
RE
3
MPIE
2
TEIE
Initial Value
R/W
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
Section 14 Serial Communication Interface (SCI)
Description
Transmit Interrupt Enable
When this bit is set to 1, a TXI interrupt request is
enabled.
Receive Interrupt Enable
When this bit is set to 1, RXI and ERI interrupt
requests are enabled.
Transmit Enable
When this bit is set to 1, transmission is enabled.
Receive Enable
When this bit is set to 1, reception is enabled.
Multiprocessor Interrupt Enable (enabled only when
the MP bit in SMR is 1 in asynchronous mode)
When this bit is set to 1, receive data in which the
multiprocessor bit is 0 is skipped, and setting of the
RDRF, FER, and ORER status flags in SSR is
disabled. On receiving data in which the
multiprocessor bit is 1, this bit is automatically
cleared and normal reception is resumed. For
details, see section 14.5, Multiprocessor
Communication Function.
Transmit End Interrupt Enable
When this bit is set to 1, a TEI interrupt request is
enabled.
Rev. 1.00 May 09, 2008 Page 369 of 954
REJ09B0462-0100
Advertisement
Table of Contents
