Bit
Bit Name
1
IRIC
Note:
*
Only 0 can be written to clear the flag.
Initial
Value
R/W
Description
0
R/(W)* Note: When the slave address does not match and the
[Clearing condition]
When 0 is written in IRIC after reading IRIC = 1
Section 17 I
general call address is not detected (with all flags
of AAS, AASX, and ADZ cleared to 0),
transmission and reception do not proceed. Thus,
the ICDRE and ICDRF flags will not be set. Nor
will the IRIC flag. However, even in this case, if
STOPIM is 0, the IRIC flag is set by condition 3
above. If detection of a stop condition is not
necessary, set STOPIM to 1 to disable setting of
the IRIC flag.
Rev. 1.00 May 09, 2008 Page 507 of 954
2
C Bus Interface (IIC)
REJ09B0462-0100