Table of Contents
Advertisement
2. Description of Numbers and Symbols
Aspects of the notations for register names, bit names, numbers, and symbolic names in this
manual are explained below.
(1) Overall notation
In descriptions involving the names of bits and bit fields within this manual, the modules and
registers to which the bits belong may be clarified by giving the names in the forms
"module name"."register name"."bit name" or "register name"."bit name".
(2) Register notation
The style "register name"_"instance number" is used in cases where there is more than one
instance of the same function or similar functions.
[Example] CMCSR_0: Indicates the CMCSR register for the compare-match timer of channel 0.
(3) Number notation
Binary numbers are given as B'nnnn (B' may be omitted if the number is obviously binary),
hexadecimal numbers are given as H'nnnn or 0xnnnn, and decimal numbers are given as nnnn.
[Examples] Binary:
(4) Notation for active-low
An overbar on the name indicates that a signal or pin is active-low.
[Example] WDTOVF
14.2.2 Compare Match Control/Status Register_0, _1 (CMCSR_0, CMCSR_1)
CMCSR indicates compare match generation, enables or disables interrupts, and selects the counter
input clock. Generation of a WDTOVF signal or interrupt initializes the TCNT value to 0.
14.3 Operation
14.3.1 Interval Count Operation
When an internal clock is selected with the CKS1 and CKS0 bits in CMCSR and the STR bit in
CMSTR is set to 1, CMCNT starts incrementing using the selected clock. When the values in
CMCNT and the compare match constant register (CMCOR) match, CMCNT is cleared to H'0000
and the CMF flag in CMCSR is set to 1. When the CKS1 and CKS0 bits are set to B'01 at this time,
a f/4 clock is selected.
Note: The bit names and sentences in the above figure are examples and have nothing to do
with the contents of this manual.
Rev. 1.00 May 09, 2008 Page vi of xxvi
B'11 or 11
Hexadecimal: H'EFA0 or 0xEFA0
Decimal:
1234
(4)
(2)
Rev. 0.50, 10/04, page 416 of 914
(3)
Advertisement
Table of Contents
