Table of Contents
Advertisement
Section 1 Overview
Notes: 1. Pins PE4 to PE1 are not supported by the system development tool (emulator).
2. Following precautions are required on the reset signal that is applied to the ETRST pin.
The reset signal should be applied to ETRST pin on power supply if the input voltage of
the RES pin is low.
Set apart the circuit from this LSI to prevent the ETRST pin of the emulator from
affecting the operation of this LSI.
Set apart the circuit from this LSI to prevent the system reset of this LSI from affecting
the ETRST pin of the emulator.
Rev. 1.00 May 09, 2008 Page 28 of 954
REJ09B0462-0100
Advertisement
Table of Contents
