Section 27 List Of Registers - Renesas H8S/2100 Series Hardware Manual

6-bit single-chip microcomputer
Hide thumbs Also See for H8S/2100 Series:
Table of Contents

Advertisement

The list of registers gives information on the on-chip register addresses, how the register bits are
configured, the register states in each operating mode, the register selection condition, and the
register address of each module. The information is given as shown below.
1. Register addresses (address order)
• Registers are listed from the lower allocation addresses.
• For the addresses of 16 bits, the MSB is described.
• Registers are classified by functional modules.
• The access size is indicated.
• H8S/2140B Group compatible register addresses or extended register addresses are selected
depending on the RELOCATE bit in system control register 3 (SYSCR3).
When the extended register addresses are selected, the some register addresses of TMR_Y and
PORT are changed. Therefore, the selection with other module registers that share the same
addresses with these registers is not necessary.
2. Register bits
• Bit configurations of the registers are described in the same order as the register addresses in
section 27.1, Register Addresses (Address Order).
• Reserved bits are indicated by " " in the bit name column.
• The bit number in the bit-name column indicates that the whole register is allocated as a
counter or for holding data.
• Each line covers eight bits, and 16-bit register is shown as 2 lines, respectively.
3. Register states in each operating mode
• Register states are described in the same order as the register addresses in section 27.1,
Register Addresses (Address Order).
• The register states described here are for the basic operating modes. If there is a specific reset
for an on-chip peripheral module, see the section on that on-chip peripheral module.
4. Register selection conditions
• Register selection conditions are described in the same order as the register addresses in
section 27.1, Register Addresses (Address Order).
• For register selection conditions, see section 3.2.2, System Control Register (SYSCR), section
3.2.3, Serial Timer Control Register (STCR), section 26.1.3, Module Stop Control Registers H,
L, A, and B (MSTPCRH, MSTPCRL, MSTPCRA, MSTPCRB), or register descriptions for
each module.

Section 27 List of Registers

Section 27 List of Registers
Rev. 1.00 May 09, 2008 Page 825 of 954
REJ09B0462-0100

Advertisement

Table of Contents
loading

This manual is also suitable for:

H8s/2112r

Table of Contents