8.2.14
Port E
(1)
PE4/ETMS, PE3/ETDO, PE2/ETDI, PE1/ETCK
The pin function is switched as shown below according to the operating mode.
Operating mode
Pin function
Note: Pins PE4 to PE1 are not supported by the system development tool (emulator).
(2)
PE0/ExEXCL
The pin function is switched as shown below according to the combination of the EXCLS bit in
PTCNT0 and the EXCLE bit in LPWRCR.
When the EXCLS bit in PTCNT0 and the EXCLE bit in LPWRCR are set to 1 in this order, this
pin functions as the ExEXCL input pin.
EXCLS
EXCLE
Pin function
On-chip emulation mode
Emulator input/output
0
PE0 input pin
Single-chip mode
1
0
PE0 input pin
Rev. 1.00 May 09, 2008 Page 185 of 954
Section 8 I/O Ports
PEn input
(n = 4 to 1)
1
ExEXCL input pin
REJ09B0462-0100