Fsi Access Host Base Address Registers H And L (Fsihbarh And Fsihbarl) - Renesas H8S/2100 Series Hardware Manual

Section 21 FSI Interface

21.3.10 FSI Access Host Base Address Registers H and L (FSIHBARH and FSIHBARL)

FSIHBARH and FSIHBARL store the upper 16 bits of the host start address which is necessary to
convert the host address to the SPI flash memory address. The input range of the host address will
be determined based on the host start address set in these registers and the memory size set in
FSISR. If a host address to be input is out of the determined range, Sync will not be returned. If
FW memory cycle is used, bit 31 to bit 28 in FSIHBARH is set as IDSEL. During FSI operation
(in the state where FSIE or FSILIE is set), do not change the setting in this register.
• FSIHBARH
Bit Bit Name
7 to 0 bit 31 to
bit 24
• FSIHBARL
Bit Bit Name
7 to 0 bit 23 to
bit 16
Rev. 1.00 May 09, 2008 Page 660 of 954
REJ09B0462-0100
R/W
Initial
Value EC Host Description

All 0 R/W
R/W
Initial
Value EC Host Description

All 0 R/W
These bits specify bits [31:24] of the host start
address.
These bits specify bits [23:16] of the host start
address.
The settings by bit 19 to bit 16 do not affect the
operation.