Neighbor Prefix-Tree - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

neighbor prefix-tree

neighbor { ipAddress | ipv6Address | peerGroupName }
Syntax
prefix-tree prefixTreeName { in | out }
no neighbor { ipAddress | ipv6Address | peerGroupName }
prefix-tree [ prefixTreeName ] { in | out }
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Assigns an inbound or outbound prefix tree. The no version removes the prefix tree.
Description
Options
Address Family Configuration, Router Configuration
Mode
56
neighbor prefix-tree
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor; valid only under the IPv4 address
family for advertising IPv4 routes over BGP IPv6 peers
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command, unless it is overridden for a
specific peer.
prefixTreeName Name of a BGP prefix tree
in Assigns prefix tree to incoming routes (inbound policy)
out Assigns prefix tree to outgoing routes (outbound policy); you cannot
configure a member of a peer group to override the inherited peer group
characteristic for outbound policy