Neighbor Filter-List - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

neighbor filter-list

To apply an access list:
Syntax
neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
accessListName { in | out }
no neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
[ accessListName ] { in | out }
To assign a weight:
neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
accessListName weight value
no neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
[ accessListName ] weight [ value ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Applies an AS path access list to advertisements inbound from or outbound to the
Description
specified neighbor, or assigns a weight to incoming routes that match the AS path
access list. The no version stops the application of the list or assignment of the weight.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command, unless it is overridden for a
specific peer.
accessListName Name of a single AS path access list; string of up to 32 characters
in Applies access list to incoming routes (inbound policy)
out Applies access list to outgoing routes (outbound policy); you cannot configure
a member of a peer group to override the inherited peer group characteristic for
outbound policy
value Number in the range 0–65535; assigns relative importance to incoming
routes matching AS paths
Chapter 2: N Commands
39
neighbor filter-list